Oil Pressure Switch Removal and Installation
Refer to "Electrical Components Location in Section 0A
(Page 0A-7)".
Removal
1) Turn the ignition switch OFF.
2) Drain engine oil. Refer to "Engine Oil and Filter
Replacement in Section 0B (Page 0B-11)".
3) Disconnect the oil pressure switch lead wire.
4) Remove the oil pressure switch (1).
1
Installation
1) Install the oil pressure switch (1), apply the bond to
its thread part and tighten it to the specified torque.
: Sealant 99000–31140 (SUZUKI Bond
1207B or equivalent)
Tightening torque
Oil pressure switch (a): 14 N·m (1.4 kgf-m, 10.0
lb-ft)
B822H11506006
I822H1150018-01
I822H1150019-01
1
(a)
I822H1150020-02
Engine Lubrication System:
2) Connect the oil pressure switch lead wire securely.
Refer to "Wiring Harness Routing Diagram in
Section 9A (Page 9A-7)".
Tightening torque
Oil pressure switch lead wire bolt (b): 1.5 N·m (
0.15 kgf-m, 1.0 lb-ft)
3) Pour engine oil. Refer to "Engine Oil and Filter
Replacement in Section 0B (Page 0B-11)".
Oil Pressure Switch Inspection
Refer to "Oil Pressure Indicator Inspection in Section 9C
(Page 9C-8)".
Oil Jet Removal and Installation
Oil Jet (For Cam Chain Tension Adjuster)
Removal
1) Remove the each cam chain tension adjuster. Refer
to "Engine Top Side Disassembly in Section 1D
(Page 1D-25)".
2) Remove the oil jet (1).
1
1E-7
(b)
I822H1150023-02
B822H11506007
B822H11506008
1
I822H1150024-01