SENSORS
CKP SENSOR INSPECTION
The crankshaft position sensor is installed in the generator
cover. (Page 44)
CKP SENSOR REMOVAL AND INSTALLATION
• Remove the generator cover. (RV125K3 3-14)
• Install the generator cover in the reverse order of removal.
IAP/TP/IAT SENSOR INSPECTION
The intake air pressure sensor/throttle position sensor/intake air
temperature sensor are combined into one and installed in the
throttle body. (Page 47, 52 and 61)
Do not attempt to remove the IAP/TP/IAT sensor from
the throttle body. It is available only as a throttle body
assembly.
ET SENSOR INSPECTION
The engine temperature sensor is installed in the cylinder.
(Page 57)
• Remove the ET sensor. (Page 80)
• Check the ET sensor by testing it at the bench as shown in
the figure. Connect the ET sensor 1 to a circuit tester and
place it in the oil 2 contained in a pan, which is placed on a
stove.
• Heat the oil to raise its temperature slowly and read the col-
umn thermometer 3 and the ohmmeter.
RV125K7 ('07-MODEL) 79