Sensors; Iap Sensor Inspection; Iap Sensor Removal/Installation; Tp Sensor Inspection - Suzuki GSX1400 Service Manual

SENSORS

IAP SENSOR INSPECTION

The intake air pressure sensor is located at the upper frame be-
tween the tubes. ( 4-33)

IAP SENSOR REMOVAL/INSTALLATION

• Lift and support the fuel tank. (
• Remove the IAP sensor 1 and disconnect the coupler 2 and
vacuum hose 3.
• Installation is in the reverse order of removal.

TP SENSOR INSPECTION

The throttle position sensor is installed on the No.1 throttle body.
( 4-35)

TP SENSOR REMOVAL/INSTALLATION

• Lift and support the fuel tank. (
• Remove the TP sensor setting screws 1 and disconnect its
coupler.
• Install the TP sensor to the No.1 throttle body. Refer to page 4-
64 for TP sensor setting procedure.

STP SENSOR INSPECTION

The secondary throttle position sensor is installed on the No. 4
throttle body. ( 4-43)

STP SENSOR REMOVAL/INSTALLATION

• Lift and support the fuel tank. (
• Remove the STP sensor setting screws 1 and disconnect its
coupler.
• Install the STP sensor to the No. 4 throttle body. Refer to page
4-62 for STP sensor setting procedure.

CKP SENSOR INSPECTION

The signal rotor is mounted on the right end of the crankshaft,
and the crankshaft position sensor (Pick-up coil) is installed on
the right side of the crankcase. (

CKP SENSOR REMOVAL/INSTALLATION

( 3-15 and -69)
www.GSX1400FE.com
4-48)
4-48)
4-48)
4-32)
FI SYSTEM 4-67