Remote Communication And Control; Connection Options; Rs-232 Port - Extron electronics SMP 351 User Manual

Remote
Communication and
Control
This section describes SIS programming and control of the SMP 351, including:
•
•
•

Connection Options

The SMP 351 Streaming Media Processor can be remotely connected via a host computer
or other device (such as a control system) to the rear panel RS-232 port or LAN port, or the
front panel USB Config port.
The SMP 351 can be configured and controlled using SIS commands or embedded web
pages. SIS commands can be executed using the Extron DataViewer program, found on
the Extron Website at www.extron.com.
RS-232 protocol defaults:
•
•
See
USB port details:
The Extron USB driver must be installed before use (see
Front Panel Configuration Port
LAN port defaults:
DHCP:
SMP 351 IP address: 192.168.254.254
Subnet mask:
Gateway IP address: 0.0.0.0

RS-232 Port

The SMP 351 has a rear panel serial port (see item
connected to a host device such as a computer running a HyperTerminal utility, or
the Extron DataViewer utility. The port makes serial control of the media processor
possible. Use the protocol information listed above to make the connection (see
Host-to-device Communications
Connection Options
Host-to-device Communications
Command and Response Tables
9600 baud • no parity
8 data bits • no flow control
RS-232 Port below, for additional details on connecting the RS-232 port.
off
255.255.0.0
• 1 stop bit
on page 148) .
on page 12) that can be
E
on page 150).
SMP 351 • Remote Communication and Control
147