Extron electronics SMP 351 User Manual page 149

To create monitors:
1. From within the digital I/O configuration app, click the Monitor tab. You are prompted
to either save (click Yes) or discard (click No) any changes made within the Config
page. The Monitor page (shown below), allows you to select up to three specific
conditions for the SMP 351 to monitor and up to three actions for the unit to take when
the conditions occur.
2. For each condition, select a condition from the drop-down list on the left, then select
the appropriate state from the drop-down list on the right. Options for conditions and
states are listed in the following table.
Conditions
Digital I/O n
Record Mode
Audio Mute Channel A
Audio Mute Channel B
Video Mute Channel A
Video Mute Channel B
A/V Mute
Active Alarm
Inactive Alarm
States or Options
On
Off
Inactivity >
Inactivity <
Recording
Stopped
Paused
On
Off
On
Off
On
Off
On
Off
On
Off
Audio Loss
Disk Space
Disk Error
HDCP Video
Record Halt
Video Loss
Audio Loss
Disk Space
Disk Error
HDCP Video
Record Halt
Video Loss
Notes
0 to 600 minutes
0 to 600 minutes
SMP 351 • Applications 143