Command And Response Tables - Extron electronics SMP 351 User Manual

Command and Response Tables

SIS Command
Command
Function
(Host to Device)
Information requests
An asterisk (*) after the version number indicates the currently running version. Question marks (?.??) indicate that only
NOTE:
factory firmware is loaded. A caret (^) indicates the firmware version that should be running, but a Mode 1 reset (see
SMP 351 Rear Panel Reset
exclamation point (!) indicates corrupted firmware.
Firmware version
Q/q or 1Q
Firmware and build
*Q/q
version
Verbose version
0Q
info
Bootstrap Version
2Q
Factory Firmware
3Q
Version
Example: 3Q
Updated firmware
4Q
version
Example: 4Q
Query part number
N/n
Query model name
1I/1i
Query model
2I/2i
description
Query system
3I
memory usage
View number of
10I
connected users
View system
11I
processor usage
View system
12I
processor idle
View eth link
13I
0
status
View file transfer
38I
config
View active alarms
39I
NOTES: X1! = Version number
Response
(Device to Host)
on page 16) was executed and the default factory firmware is running. An
X1!]
X1!]
Sum of
2Q-3Q-4Q
X1! ]
X1!
plus Web ver.-desc-UL date/
]
time
1.00.0000-b2325(1.81LX-
SMP 351 -Sat, 01 Nov 2014
20:10 UTC)
X1!
plus Web ver.-desc-UL date/
]
time
1.00.0004-b2635*(1.81LX-
SMP 351 -Sun, 02 Nov 2014
00:12 UTC)
]
60-1324-01
]
SMP •351
Streaming•Media•Processor
#Bytes used out of #KBytes
# of users
Returns a percentage of total.
Returns a percentage of total.
Current link state (up/down)*
speed in MB (10/100/1000)*
mode (full/half).
[name:alarm_name],[level:alarm_level]...]
Firmware version number to second decimal place (x.xx)
Version and Build number adds four digits (x.xx.xxxx)
to the Version number
SMP 351 • Remote Communication and Control
Additonal Description
Firmware version to 2 decimal
places (1.00)
Firmware version to 2 decimal
places plus build number to 4
decimal places (1.12.1234)
]
Show bootstrap, factory-
installed, and updated firmware
version.
The bootstrap firmware is
not user replaceable but you
may need this information for
troubleshooting.
Factory installed firmware is not
user replaceable. This firmware is
the version the SMP 351 reverts
to after a mode 1 reset.
Use this command to find
out which version of firmware
has been uploaded into the
SMP 351.
]
]
in json format
155