Extron electronics SMP 351 User Manual page 25

Record controls with LED indicators – Press the Record, Stop, Pause, and Mark
D
buttons to perform the operation. The buttons light to indicate the current state of
record operation.
Record – Press
•
during active recording.
Stop – Press to stop the active recording. When pressed during a recording,
•
the stop button blinks green while the recorded file is being finalized, then lights
solid green when the file is finalized.
Pause – Press
•
green to indicate recording is paused. Press Record or press Pause again to
resume recording, or press Stop to halt the recording.
Mark – Press to place a chapter marker in the recorded file. When pressed
• MA RK
during recording, the button illuminates green momentarily to indicate a chapter
marker is inserted. The button also illuminates when JPEG thumbnails are
automatically created at 5 minute internals.
Audio level indicators – Two stacks of eight green LEDs track the audio level of the
E
left and right audio channels from -60 dBFS (one LED) to 0 dBFS (eight LEDs). The
LEDs indicate both signal presence and active input signal levels.
Input Configuration Mode – When input gain is adjusted, the meters display the
•
currently selected input left and right channel audio levels to assist setting audio
gain (see Audio level
Normal Mode – The meters display the left and right encoder input levels.
•
Layout Preset and Swap – Press Layout Preset to select one of the 16 capture
F
presets (see Layout Presets
Adjust knobs ( ) to select the desired output layout. Press Next (
I
Press Swap to switch Channel A and B inputs between the two layout windows. The
button illuminates green for 1 second to indicate the input swap.
Menu display – Displays configuration menus and status information. Use the Menu
G
and Next buttons ( ) and Adjust knobs (
H
operation, a default display cycle is presented. If there is an active alarm (see
page 44), it is listed instead.
Menu Navigation (Menu and Next) – Lights amber (unless menu lockout is enabled).
H
Press to access and navigate the configuration and control menus and submenus.
NOTE: The menu button blinks red when there is an active alarm (see
page 44).
Menu — Use this button to enter and move through the main menu system.
Next — Use this button to step through the submenus of the menu system.
Adjust knobs (left [ and right {) – Rotate these controls to scroll through menus
I
and to make adjustments within a menu or submenu.
NOTE: The buttons and controls on the SMP 351 can be locked
so that configuration using the front panel is not possible (see
Front Panel Lockout (Executive Modes)
I/O display – A stack of four green LEDs that correspond to the four digital I/O
J
connections on the rear panel (see
on or off status of the corresponding ports which can be configured as digital input or
About the Digital I/O Configuration App
digital output (see
to record the selected inputs. The record button lights solid red
to pause recording. When pressed, the Pause button blinks
on page 37).
on page 20). The button illuminates green. Use the
) to navigate the menu. During normal
I
on page 43).
figure 3 on page 12). Each LED indicates the
) to activate it.
H
Alarms
Alarms on
on page 140).
SMP 351 • Operation
on
19