Smp 351 Rear Panel Reset - Extron electronics SMP 351 User Manual

SMP 351 Rear Panel Reset
The Reset button on the rear panel of the SMP 351 (see
the SMP 351 to various modes of operation. To select different reset modes, use a pointed
stylus or small screwdriver to press and hold the Reset button while the SMP 351 is
powered or press and hold the Reset button while applying power to the SMP 351.
NOTES:
ATTENTION:
There are three unit reset modes (numbered 1, 4, and 5) that are initiated from the rear
panel reset button. Press the button with a pointed stylus, pen, or similar item to access the
modes. See the following table for a summary of the reset modes.
Mode 1
Modes 4
Press and hold for
6 seconds.
Modes 5
Press and hold for
9 seconds.
Figure 6.
• The reset modes listed in the table on the Next page close all open IP and Telnet
connections and all sockets.
• Each reset mode is a separate reset (not a continuation from mode 1 to mode 5).
• Reset modes 2 and 3 are not available for the SMP 351.
•
The SMP 351 can also be reset using the Web-based user interface (see
System Resets on page 139).
• For information on resetting the SMP 351 using SIS commands, see
page 156.
• Further details comparing the reset modes and detailing affected configuration
settings and user content are available in the operations section below.
•
Review the reset modes carefully.
• Étudier de près les différents modes de réinitialisation.
• Some reset modes delete all user loaded content and revert the device to default
configuration.
• Certains modes de réinitialisation suppriment la totalité du contenu chargé de
l'utilisateur et remettent l'appareil en mode de configuration par défaut.
RESET
Press and hold
the Reset button.
RESET
RESET
Resetting the SMP 351
figure 3
RESET
Apply power
to the SMP 351.
Release, then immediately
Reset LED flashes twice. press and release again. Reset
LED flashes, then goes off.
RESET
RESET
Release, then immediately
Reset LED flashes three press and release again. Reset
times. LED flashes, then goes off.
RESET RESET
SMP 351 • Panels and Cabling
on page 12) returns
Resets on
Release Reset button.
16