Smp 351 Power Up Procedure; Front Panel Menu Operation; Menu Navigation - Extron electronics SMP 351 User Manual

SMP 351 Power Up Procedure
NOTE: Before powering the SMP 351, ensure that all necessary devices are connected
Connect the power cord to a 100 to 240 VAC supply (see
page 13). The unit undergoes self testing during the boot sequence (see figure 14). After
the sequence is complete (and when the device is not being configured or has an active
alarm), the default display cycle is on the LCD display.
2
EXTRON
Power sec.
ELECTRONICS
On
~4
sec.
30
LOADING
sec.
FIRMWARE
NOTE: The information shown in the default display cycle differs
depending on the active input and the type of video signal.
Time Record displays only during a recording.
Time Remain displays the remaining time in the event and the
estimated recording time available during an unscheduled
recording.
Figure 11.
The default display cycle varies depending on the input video signal and output stream
selection. It shows the selected inputs and their resolutions, stream bitrate, and output
resolution. During recording, the current length of the recording and time remaining are
added to the default cycle (see the NOTE in figure 11, above).

Front Panel Menu Operation

Configuration and adjustments can be performed using the embedded Web
pages (see
Remote Communication and Control
and the menus displayed on the LCD screen. These menus are used primarily during the
initial set up.

Menu Navigation

Menu display (
menus on a16x2 LCD display.
MENU button (
and cycle through the main menus.
NEXT button (
submenus of the selected main menu.
ADJUST ([,{) knobs (
the left ([) control and right ({) control to scroll through
submenu options and to make configuration selections. See the
flowcharts in this chapter for details.
properly. Devices do not need to be powered.
EXTRON
SMP 351 FW V1.00
45
SMP 351
sec.
INITIALIZING
Boot Sequence and Default Display Cycle
Web-Based User Interface
) — Displays the configuration
G
CHANNEL A
1 2
CHANNEL B
3 4 5
USB STORAGE
CONFIG
) — Press Menu to activate menus
H
) — Press Next to move between the
H
I ) — In configuration mode, rotate
Power Connection
Default Display Cycle
2
In#1 1024x768@60 sec.
In#3 720p@60
2 sec.
2
sec.
TIME REMAIN
HH:MM:SS
on page 46), the SIS commands (see
on page 147), or using the front panel controls
AUDIO
L R LAYOU T
PRE SET
M ARK S WAP S WAP
Menu
PRESETS
Next
Menu Menu
ENCODER RECALL
<N/A>
Rotate either to
select a preset.
Press to recall the
selected preset.
Press to continue.
Menu Menu
ENCODER SAVE
<N/A>
Rotate either to select a
preset to save current
settings to.
Press to save the
the new preset.
Press to continue.
SMP 351 • Operation
on
ARCHIVE 2.0 MB
1280x720@10 fps
2 sec.
TIME RECORD
HH:MM:SS
ADJUST
M ENU I/O
1
2
3
NEXT NEXT
4
PICTURE
Menu
CONTROL
Next
CHANNEL SELECT
<A> <ON>
Rotate to select a channel.
Rotate to turn the channel
on or off.
Next
H POSITION [A] V
<+0000> <+0000>
Rotate to adjust Horizontal
Position.
Rotate to adjust Vertical
Position.
Next
21
SM
PRESENTATION CAPTURE