Dmp Software; Software Control - Extron electronics DMP 128 User Manual

DMP Software

This section describes the control software for the DMP 128, including:
•
•
•
•
•
•
•
•
•
•
•

Software Control

The DMP 128 can be controlled using the DSP Configurator software, using SIS commands
with hyper terminal or Extron DataViewer (see
page 129), and accessed using embedded Web pages (see
page 156).
The DMP 128 has the following connection options:
•
•
•
Software Control
Software Installation
DSP Configurator Program Basics
Audio level, Mix-point, Processing
Blocks, and Signal Chains
Mic/Line Input Signal Chain
Controls
Line Output Channels
Virtual Bus Returns
Output Mix Matrix
Virtual Send Bus Mix Matrix
Expansion Outputs Mix Matrix
Extron EXP Bus
RS-232 — One single 3.5 mm, 3-pole captive screw connector is used for bi-directional
RS-232 ( ± 5 V) serial control. See
for additional details on connecting the RS-232 port.
LAN — 10 Mbps, 100 Mbps, half duplex, full duplex connections are supported. Two
LEDs indicate connection and activity status. The device has the following default
Ethernet configurations:
IP Address: 192.168.254.254
Subnet Mask: 255.255.0.0
See Rear Panel Features and Cabling
page 129 for additional details on connecting the LAN.
USB 2.0 — A USB mini-B connector located on the front panel provides high-speed
USB 2.0 connectivity to a host computer, backward compatible to 1.0.
• Device Manager
• AT (Dante) Bus
• Group Masters
• Digital I/O Ports
• Emulate Mode and Live Mode
• Presets
• Protected Configuration
• DSP Configurator Windows Menus
• Optimizing Audio Levels
• Signal Path Building Blocks
SIS Programming and Control
HTML Operation
Rear Panel Features and Cabling
Default Gateway: 0.0.0.0
DHCP: OFF
on page 6, and Connection Options
DMP 128 • Software Control
on
on
on page 6,
on
12