Extron electronics SMP 351 User Manual page 122

Restore a Configuration
To restore a configuration to the unit or to load a configuration saved from another SMP:
1. In the System Settings page, click the Expand arrow button for the Backup and
Restore pane to expand it. The pane opens.
2. Click Browse. The Open dialog box opens.
3.
Browse to and select the desired file, which must be IP.cfg or Box.cfg from an
Extron SMP 351 .
4. Click Open. The dialog box closes and the file name appears in the Select a
configuration file to upload: field.
5. Click Upload. It takes a few moments for the configuration upload to the SMP 351.
The unit reboots upon completion. A dialog box may appear to remind you to reload the
Web pages in the browser.
6. If the configuration file is from a different unit connected to the same
network, set the IP address of this SMP 351 to a different number (see
Setting the IP address, port numbers, and other network settings
so there are no network conflicts.
Executive modes (Front Panel Lock-out)
Use of front panel controls and functions can be limited or completely disabled by setting
one of the levels of front panel lock-out, also known as executive modes. To limit or disable
front panel control:
1. In the System Settings page, click the Expand arrow button for the Executive
Mode pane to expand it. The pane opens.
2. Select an option from the Front Panel Exec Mode drop-down list:
Exec Mode Disabled — Executive mode is off. All front panel controls are active
•
and accessible.
Complete Lock-out — Executive mode 1 is active. All front panel controls are
•
disabled.
Menu Lock-out — Executive mode 2 is active. Menu access is disabled, but input
•
switching, capture preset, swap and recording controls are available.
Allow Recording Controls only — Executive mode 3 is active. All front panel
•
controls are disabled except the Record, Pause, Stop, and Mark buttons.
3. Click Save to activate the selection or click Cancel to discard the change.
SMP 351 • Web-Based User Interface
on page 109)
116