Extron electronics SMP 351 User Manual page 150

3. By default, the SMP 351 monitors only the first condition (condition 1). To have the
unit monitor conditions 2 or 3, select (check) the check box adjacent to each desired
condition. If you set up condition 2 or condition 3 but decide not to monitor it, deselect
the corresponding check box. Condition 1 and action 1 are automatically selected and
cannot be deselected or deactivated.
NOTE: All selections for condition or action 2 or 3 are cleared once its check box is
deselected. Re-selecting the check box does not restore the previously selected
choices for the condition or action.
4.
Set up the action or actions the SMP 351 will take when it detects all the monitored
conditions. To do so, select an action from the drop-down list on the left, then select the
appropriate state from the drop-down list on the right. Options for actions and states
are listed below.
Actions
Digital I/O n
Record Mode
Audio Mute Channel A
Audio Mute Channel B
Video Mute Channel A
Video Mute Channel B
A/V Mute
Input Switch
Swap
Chapter Marker
States or Options
On
Off
Pulse
Toggle
Record
Stop
Pause
Extend by 10 minutes
On
Off
On
Off
On
Off
On
Off
On
Off
1
2
3
4
5 (3G-SDI model only)
Notes
This is only an option
if the digital I/O port
is set for output, or
output with pull-up.
Identical to the
AV Controls panel
options (see
AV Controls Panel
page 54)
Select the number of
the input to switch to.
Swap video from
channel A and channel
B.
Insert a chapter marker
into the recorded
video.
SMP 351 • Applications
on
144