Extron electronics SMP 351 User Manual page 126

1. Open a Web browser and navigate to the SMP 351 product page at www.extron.com.
2. Within the product page, click on the Downloads tab.
3.
In the Software listing section, locate the link for the desired plug-in and click on the link
to start the download process.
4. Complete the information form if requested to do so, then click Download and follow
the on-screen instructions.
5. Note the name of the plug-in and location on the computer where it was downloaded.
6. In another Web browser tab or window, type the IP address of the SMP 351 into the
address field and open its Web pages.
7. Click Configuration>Advanced Features at the top of the SMP 351 embedded
Web pages.
8. In the Apps panel, click Browse. An Open dialog box opens.
9. Navigate to the location of the downloaded file and select the file.
10. Click Open. The Open dialog box closes.
11. Click Install. The file uploads to the SMP 351. Once it is installed, the name of
the application is listed in the table within the Apps panel, along with its settings for
start-up state, current running state (running or stopped and ready to start), and status
(purpose).
12. If desired, you can sort the applications list by clicking on a column title (such as App
Name) and selecting the desired option: Sort Ascending or Sort Descending.
Available applications
Digital I/O configuration — The digital I/O configuration (Digital I/O) application is included
with the SMP 351 . It makes it possible to rename each digital input/output port, set its use
mode (input or output, with or without pull-up), create labels for on and off states, and see
the status of each port. Additionally, this application lets you link monitored conditions (such
as the state of a particular I/O port, a specific recording mode or mute state or alarm) with
actions (changing an input, recording mode, or mute mode, or swapping channels or setting
a chapter marker).
Additional applications may become available in the future for download from the Extron
Website.
Open and use an application
To open and use an application that has been uploaded to the SMP:
1. Click Configuration>Advanced Features on the embedded Web pages. The
Advanced Features page opens.
2. Within the Apps panel, click the Configure button corresponding to the desired
application in the Actions column. The application opens in a new window.
3. Change settings for the features covered by that plug-in as desired. For example, select
input or output and select or deselect a pull-up resistor for a digital I/O port.
4. Click Apply or Save to save the configuration settings and close the application
window, or click Cancel to discard the settings and close the window. Details about
the features and use of each plug-in may be covered by a help file specific to the
plug-in.
SMP 351 • Web-Based User Interface 120