Extron electronics SMP 351 User Manual page 92

The first nine presets are populated with factory configurations which can be overwritten.
Presets 10 through 16 are configured on the Encoding & Layout page.
NOTE: Some of the parameters available on this page can also be set individually using
front panel controls.
An overview of encoding
Each of the two types of encoding for the SMP 351 can be used for multiple purposes. It
can be useful to understand how each encode is typically used and the differences. The
following table details the two encodes, their typical use, the conditions and differences from
each other and additional comments.
Encoding Stream Uses
Archive Recording
Encoding
Local HDMI output
through the rear panel
Output (preview) port
Live stream via the
LAN port and network
if using a decoder
application
Confidence
Preview window in the
Encoding AV Controls panel
of the embedded Web
pages
Live stream via the
LAN port and network
if using a decoder
application
Conditions or Comment
Differences
Refresh rate: 5 to 30 fps Highest quality and
resolution
Refresh rate: 50 or 60 Hz
Does not use the
compression settings
specified in the archive
encoding preset.
This output bypasses
compression and
encoding.
Refresh rate: 5 to 30 fps
(same as the recording
stream)
Must always be lower
resolution than archive
encoding
SMP 351 • Web-Based User Interface 86