System Settings - Extron electronics SMP 351 User Manual

Alarm Priority Alarms and
Traps Severity
Level
High Notify
Normal Display
Low
NOTE: If internal storage space is nearly full (at the point when the disk space alarm is
triggered) and the SMP 351 is set up to automatically upload recordings
to a server (see Set a default recording destination
Scheduling with an opencast Matterhorn server
disc cleanup feature to make room for new recordings. As the need arises, the unit automatically deletes
recordings that have been uploaded to a server, starting with the oldest recordings, until there is enough
free space on the disk (see
recording.

System Settings

Controls within six of the nine panes in the System Settings page within
Configuration are essential during initial setup of the unit. The three other panels
contain features that are used infrequently for updating the unit, restoring a configuration, or
limiting access to front panel controls. A user must be logged in as an administrator to see
or change these settings.
To open this page, click the Configuration tab at the top of the SMP 351 embedded
Web pages and then click the System Settings tab on the second tier of tabs.
The System Settings page opens. It features nine panes, each with its own panel:
Unit Identification – Set the system (unit) name and a descriptive name for its location.
•
• Date and Time – Set the date, time, time zone, and settings for syncing with one or
more NTP (network time protocol) servers.
Networking – Set the IP addresses for the unit, gateway, and DNS server, as well as
•
the subnet mask and port numbers for a variety of port types.
Default Recording Destination – Choose where a recording is saved during its
•
creation, select the protocol for uploading presentation recordings to a server, configure
settings for the default FTP server, and test the connection.
Default Recording File Names – Choose the type of information used to compose
•
names of recordings.
• Serial – Set the mode of use, baud rate, and protocol for the rear panel remote control
serial port.
• Firmware Loader – Upload firmware to the unit.
Backup and Restore – Upload a previously-saved configuration file to the unit.
•
• Executive Mode – Enable or disable various levels of front panel lock-out to limit
Troubleshooting
Log Severity
Level
Alert
Notice
Log Info
Disk Cleanup (Internal Storage Only)
Comments
• Sends an e-mail to the specified recipient when
the alarm is triggered
• Displays the alert on the SMP 351 front panel.
• Logs the alarm condition.
• Displays the alert on the SMP 351 front panel.
• Logs the alarm condition.
Logs the alarm condition.
•
on page 111 and
on page 68), then the SMP 351 uses an automatic
on page 123) for the current
SMP 351 • Web-Based User Interface 106