Dmp Software; Software Control - Extron electronics DMP 128 User Manual

DMP software

This section describes the control software for the DMP 128, including:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

software control

The DMP 128 can be controlled using the DSP Configurator software, using SIS
commands with hyper terminal or DataViewer (see
on page 129), and accessed using embedded WebPages (see
page 155).
The DmP 128 has the following connection options:
•
•
•
Software Control
Windows-based Program Control
DSP Configurator Program Basics
Audio level, mix-point, Processing Blocks, and Signal Chains
mic/Line Input Signal Chain Controls
Telephone Rx (DmP 128 C P and DmP 128 C P AT only)
Line Output Channels
virtual Bus Returns
Output mix matrix
virtual Send Bus mix matrix
Expansion Outputs mix matrix
Group masters
Digital I/O Ports
Emulate mode and Live mode
Presets
Protected Configuration
DSP Configurator Windows menus
Optimizing Audio Levels
Signal Path Building Blocks
RS-232 — One single stack 3-pole, 3.5 mm captive screw connector is used for
bi-directional RS-232 ( ± 5 V) serial control.
See Rear Panel Features and Cabling
connecting the RS-232 port.
LAN — 10 Mbps, 100 Mbps, half duplex, full duplex connections are supported. Two
LEDs indicate connection and activity status. The device has the following default
Ethernet configurations:
IP Address: 192.168.254.254
Subnet mask: 255.255.0.0
See Rear Panel Features and Cabling
on page 129 for additional details on connecting the LAN.
USB 2.0 — A Mini B-type USB connector located on the front panel provides
high-speed USB 2.0 connectivity to a host computer, backward compatible to 1.0.
SIS Programming and Control
HTmL Operation
on page 6, for additional details on
Default Gateway: 0.0.0.0
DHCP: OFF
on page 6, and Connection Options
DMP 128 • Software Control
on
12