Dmp Software; Software Control - Extron electronics DMP 64 User Manual

DMP Software
This section describes the control software for the DMP 64, including:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

Software Control

The DMP 64 can be controlled using the DSP Configurator software, SIS commands
through hyper terminal or DataViewer, or using embedded WebPages. IP Link functions
will be available through network connection including global viewer functionality.
The DMP 64 has the following connection options:
•
•
•
Software Control
Embedded Web Pages
Windows-based Program Control
DSP Configurator Program Basics
Audio level, Mix-point, Processing Blocks, and Signal Chains
Mic/Line Input Signal Controls
Ducker Tutorials
Line Output Channels
Virtual Bus Returns
Primary Mix Matrix
Secondary Mix Matrix
Group Masters
Digital I/O Ports
Emulate Mode and Live Mode
Presets
Protected Configuration
DSP Configurator Windows Menus
Optimizing Audio Levels
RS-232 — One single stack 3-pole, 3.5 mm captive screw connector is used for
bi-directional RS-232 (±5 V) serial control.
Rear Panel Features and Cabling
See
connecting the RS-232 port.
LAN — 10 Mbps, 100 Mbps, half duplex, full duplex connections are supported. Two
LEDs indicate connection and activity status. The device has the following default
Ethernet configurations:
IP Address: 192.168.254.254
Subnet Mask: 255.255.0.0
Rear Panel Features and Cabling
See
on page 92 for additional details on connecting the LAN.
USB 2.0 — A Mini B-type USB connector located on the front panel provides
high-speed USB 2.0 connectivity to a host computer, backward compatible to 1.0.
on page 5, for additional details on
Default Gateway: 0.0.0.0
DHCP: OFF
Connection Options
on page 5, and
DMP 64 • Software Control 14