Output Mode - Extron electronics SMP 351 User Manual

Multicast IP for pull multicast
When a multicast protocol is selected, the MULTICAST IP address must be entered. Check
with the IT department for the correct multicast IP address for your network.
Enter the MULTICAST IP address:
[
Rotate the left ( ) Adjust knob to select the octet.
{
Rotate the right ( ) Adjust knob to change the address.
Destination IP for push streaming
When push streaming is selected, the DESTINATION IP address must be entered.
Enter the DESTINATION IP address:
[
Rotate the left ( ) Adjust knob to select the octet.
{
Rotate the right ( ) Adjust knob to change the address.

Output mode

When the Archive encoder is selected an option is provided to output audio and video or
video only.
Rotate either Adjust knob to select a stream method: PULL (default) or PUSH.
Resolution
Archive and Confidence encodes have independent resolution settings.
The selections are:
• 512x288 (Confidence stream only)
• 848x480
• 1024x768
• 1280x720 (default)
• 1280x1024
• 1920x1080
There are two types of encodes - Archive/Record, and Confidence
Output Rate
1 848x480
2 1280x720
3 1920x1080
4 1024x768
5 1280x1024
512x288
6*
* for Confidence stream only
Recording resolution defaults to 1280x720.
NOTES:
• If the Archive and Confidence aspect ratios do not match, the source material can
appear stretched on the confidence stream.
• The Confidence Encode cannot have a higher resolution than the Archive Encode.
Aspect Format Name
16:9 480p
16:9 720p
16:9 1080p
4:3 XGA
5:4 SXGA
16:9 WCIF
Max FPS
30
30
30
30
30
30
SMP 351 • Operation 31