Extron electronics SMP 351 User Manual page 127

5. Close the plug-in window. You may be prompted to save changes before closing the
window.
6.
Specify whether to run the application when the SMP 351 starts up or upon reboot. To
do so:
a. Click in the Startup State column of the Apps panel to access the drop-down
list.
b. Select either Enabled (default, run the app upon unit start up) or Disabled (do
not run the app upon start up).
Stop an application from running
By default, each application is set to start and run once it has been installed and configured.
You can stop the application at any time as follows:
1. Click in the Run State column in the row for that app to access the Run State
drop-down menu.
2. Change the setting from Start (default, run or start once configured) to Stop (stop or
stopped).
3. To resume running the application, select Start again.
Remove an application
To remove an application from the SMP 351:
1. In the Advanced Features>Apps pane, click Delete corresponding to the desired
application in the Actions column. A confirmation dialog box opens asking you to
confirm the deletion.
2. Click Delete to remove the app, click Cancel to leave the app installed on the unit.
SMP 351 • Web-Based User Interface 121