Extron electronics SMP 351 User Manual page 46

Universal OSD – This pattern consists of a small,
•
translucent, gray rectangle with white text overlaid atop
the source video content. It appears in the upper left of the
screen. The text includes brief text of your choice followed
by three selectable elements separated by commas (see
Setting up the universal OSD test pattern
Rotate either ADJUST knob to scroll through the the patterns. Stop on the desired
pattern and press Next. The selected test pattern is immediately output to the display.
The test pattern displays until another pattern is selected, until Off is selected from the
Test Pattern drop-down list, or until unit power is recycled.
Record Drive Limiter
This submenu allows the record drive locations to be limited or to be
fully automatic.
The following limitations can be selected:
• NOT RESTRICTED (default) – Allows recording to internal
memory and any connected drives.
• AUTO – See Record To (archive only)
• INTERNAL ONLY – Records only to the internal storage.
FRONT USB ONLY – Records to a device connected to the front USB port only.
•
• REAR USB ONLY – Records to a device connected to the rear USB port only.
Based on the top level selection, the REC LOCATION submenu under Record/Stream
Config offers different record drive options.
NOTE: Recordings are saved to the designated destination only (for example: the
FRONT USB ONLY selection limits the recording location to the front USB port even if
the drive is disconnected or fails.
Reset
The Reset submenu provides a factory reset or firmware reboot. The selections are:
To Factory – Equivalent to a ZXXX command (see
page 155). The unit is reset to factory defaults with the current firmware.
Reboot Unit – Identical to a power cycle.
A reset or reboot confirmation message appears before the reset or reboot. Upon
confirmation, the front panel LCD displays "Resetting/Rebooting Unit".
Menu
on page 75).
on page 29.
Command and Response Tables
SMP 351 • Operation
<1280X720@60Hz>
Rotate either to select a
resolution.
ADVANCED
Menu
CONFIG
AUTO MEMORY
<ON>
Rotate to toggle Auto
IN<1> AUTO IMAGE
Memory On or Off.
<OFF>
Rotate to select input.
Rotate to toggle on or off.
TEST PATTERN
<N/A>
Rotate either to select a
PREVIEW HDMI OUT
test pattern.
<1280X720@60Hz>
Rotate either to select a
resolution.
RECORD DRIVE LIMITER
<NOT RESTRICTED>
Rotate either to select
AUTO MEMORY
the drive restriction.
<ON>
Rotate to toggle Auto
Memory On or Off.
RESET
<NONE>
Rotate either to select reboot or
TEST PATTERN
to reset all advanced configurations.
<N/A>
Rotate either to select a
test pattern.
RECORD DRIVE LIMITER
<NOT RESTRICTED>
Rotate either to select
the drive restriction.
RESET
<NONE>
Rotate either to select reboot or
to reset all advanced configurations.
on
40