Extron electronics SMP 351 User Manual page 40

Next
INPUT SELECT
<1>
Rotate either to
select input.
Signal sampling configuration
INPUT #[3]
<AUTO DETECT>
Signal sampling optimizes the input signal for the currently selected input. The signal
Rotate either to
sampling settings are only available for analog inputs.
select the input format.
(3) H START V
<128> <128>
Rotate to select the horizontal
start pixel.
Rotate to adjust the vertical
start pixel.
(3) H ACTIVE V
<1024> <0768>
Rotate to adjust Horizontal Active pixel
width.
Rotate to adjust Vertical Active pixel height.
(3) TTLPIX PHASE
<XXX> <16>
Rotate to adjust TTL pixel width.
Rotate to adjust phase.
• H START (horizontal start) and V START (vertical start) — This submenu is used to
ASPECT RATIO IN[1]
<FILL>
set the horizontal and vertical start positions of the active video for the selected input.
Rotate either to
To use this submenu:
select an aspect ratio for the
selected input.
[
Rotate the left ( ) Adjust knob to change the horizontal start pixel position (left edge)
EDID INPUT #[1]
of the active video for the selected input. The default is 128.
<720p_60_2ch>
{
Rotate the right ( ) Adjust knob to change the vertical start line position (top edge) of
Rotate to set an
EDID value for the
the active video for the selected input. The default is 128.
active input.
H ACTIVE (horizontal active pixels) and V ACTIVE (vertical active lines) — This
•
IN[1] AUDIO SELECT
submenu is used to set the horizontal active pixels and vertical active lines of the active
<LPCM 2CH>
video for the selected input.
Rotate either to
select an audio input source
To use this submenu:
for the selected input.
[
Rotate the left ( ) Adjust knob to change the width (in pixels) of the active video for
IN[1] AUDIO LEVEL
<0 dB>
the selected input.
Rotate either to set the
{
Rotate the right ( audio input level from -18 ) Adjust knob to change the height (in lines) of the active video for
to +24 dB.
the selected input.
TTLPIX (total pixels) and PHASE (pixel phase) — This submenu is used to set the
•
total pixels and pixel phase of the active video for the selected input.
To use this submenu:
[
Rotate the left ( ) Adjust knob to change the width (in pixels) of the total display area
to be sampled for the selected input.
{
Rotate the right ( ) Adjust knob to move the pixel sampling point for the selected
input. The range of settings is 000 to 063. The default is 032.
SMP 351 • Operation 34