Extron electronics SMP 351 User Manual page 35

Record To (archive only)
The Record To submenu is available when the encoder selection is Archive and Encoder
Mode is Recording On. This submenu allows you to define the drive the recorded video is
stored to. It also displays the total drive space.
NOTE: The SMP 351 can detect and record to USB storage devices using FAT32,
VFAT long file name extensions, EXT2, EXT3, or EXT4 file systems.
[
Rotate the left ( ) Adjust knob to select from the following:
• <INTERNAL> (default) – The internal storage memory and capacity (
• <USBFRONT [VOLNAME]> – An external drive connected to the front panel USB port.
• <USBREAR [VOLNAME]> – An external drive connected to the rear panel USB port.
• <AUTO> – The SMP 351 automatically selects a record destination from connected
devices and internal storage.
NOTES:
• When a USB device has more than one logical volume, each volume is
enumerated. Use the right (
volumes on USB front and USB rear storage devices.
•
When two external storage devices are detected on power up, the front panel USB
device has higher priority over a rear panel device.
• If no USB device is detected, the recording is saved to internal storage.
Auto mode uses a hiearchy to choose from attached devices and internal memory as
follows:
Device Present
USB Front USB Rear
No No
Yes No
No Yes
Yes Yes
NOTE: In Auto mode, when a physical device has more than one logical volume, only
the volume listed first (topmost) in the Web-UI for that port can be used to store
content (see step 3 of Start an Ad Hoc Recording
{
) Adjust knob to select from among the different
Record Location
Record to internal memory storage.
Record to USB Front. If USB Front is full, record to internal.
Record to USB Rear. If USB Rear is full, record to internal.
Record to USB front. If USB Front is full, record to USB rear.
If USB rear is full, record to internal.
on page 56).
GB)
xxx.xx
SMP 351 • Operation 29