Dot1X Timeout Tx-Period - Dell PowerConnect 3424 Cli Reference Manual

Syntax
dot1x timeout quiet-period seconds
no dot1x timeout quiet-period
• seconds — Specifies the time in seconds that the device remains in the quiet state
following a failed authentication exchange with the client. (Range: 0 - 65535 seconds)
Default Configuration
Quiet period is 60 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
• During the quiet period, the device does not accept or initiate authentication requests.
• The default value of this command should only be changed to adjust for unusual
circumstances, such as unreliable links or specific behavioral problems with certain clients
and authentication servers.
• To provide a faster response time to the user, a smaller number than the default value should
be entered.
Examples
The following example sets the number of seconds that the device remains in the quiet state
following a failed authentication exchange to 3600.
Console(config)# interface ethernet 1/e16
Console(config-if)# dot1x timeout quiet-period 3600

dot1x timeout tx-period

The dot1x timeout tx-period Interface Configuration mode command sets the number of
seconds that the device waits for a response to an Extensible Authentication Protocol (EAP)-
request/identity frame from the client before resending the request. To return to the default
configuration, use the no form of this command.
Syntax
dot1x timeout tx-period seconds
no dot1x timeout tx-period
• seconds — Specifies the time in seconds that the device waits for a response to an EAP-
request/identity frame from the client before resending the request. (Range: 1-65535
seconds)
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 9 / 1 3 / 0 6 – F O R P R O O F O N LY
442
802.1x Commands