Dell Networking 2024 Reference Manual page 1290

Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a 20-second dead interval for the OSPF
virtual interface on the virtual interface identified by area 1 and its neighbor.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 virtual-link 2 dead-interval 20
area virtual-link hello-interval
Use the area virtual-link hello-interval command in Router OSPFv3
Configuration mode to configure the hello interval for the OSPF virtual
interface on the virtual interface identified by
Syntax
areaid
area virtual-link
areaid
no area
areaid — Valid OSPFv3 area identifier.
•
neighbor — Router ID of neighbor.
•
seconds — Hello interval. (Range: 1-65535)
•
Default Configuration
10 is the default value for
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
1290
OSPFv3 Commands
neighbor
neighbor
virtual-link
seconds
areaid
seconds
hello-interval
hello-interval
.
neighbor
and .