Dell Networking 2024 Reference Manual page 1345

no distribute-list
accesslistname — The name used to identify the existing ACL. The range
•
is 1-31 characters.
• ospf — Apply the specific access list when OSPF is the source protocol.
• static — Apply the specified access list when packets come through a static
route.
• connected — Apply the specified access list when packets come from a
directly connected route.
Default Configuration
This command has no default configuration.
Command Mode
Router RIP Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example elects access list ACL40 to filter routes received from
the source protocol.
console(config-router)#distribute-list ACL40 out static
enable
Use the enable command in Router RIP Configuration mode to reset the
default administrative mode of RIP in the router (active). Use the no form of
the command to disable the administrative mode for RIP .
Syntax
enable
no enable
accesslistname
out {ospf | static | connected}
Routing Information Protocol Commands
1345