Example
This example shows how to configure a source switch using VLAN 723 as the
destination RSPAN VLAN and Gi1/0/3 as the source interface. Gi1/0/10 is
configured as the reflector port. It is recommended that interface gi1/0/10 be
configured as a trunk port. Interface gi1/0/10 must be configured as a member
of VLAN 723.
console(config)# monitor session 1 source interface gi1/0/3 both
console(config)# monitor session 1 destination remote vlan 723 reflector-port
gi1/0/10
console(config)# monitor session 1 mode
This example shows how to configure a destination switch using VLAN 723 as
the source RSPAN VLAN and Gi1/0/10 as the destination interface.
console(config)# monitor session 1 source remote vlan 723
console(config)# monitor session 1 destination interface gi1/0/10
console(config)# monitor session 1 mode
remote-span
Use this command to configure a VLAN as an RSPAN VLAN. Use the no
form of the command to remove the remote SPAN characteristics from a
VLAN and revert it to a VLAN.
Syntax
remote-span
no remote-span
Default Configuration
There is no default configuration for this command.
Command Modes
VLAN Configuration mode.
630
Port Monitor Commands