Ip Ospf Priority - Dell Networking 2024 Reference Manual

User Guidelines
OSPF treats interfaces as broadcast interfaces by default. Loopback interfaces
have a special loopback network type, which cannot be changed. When there
are only two routers on the network, OSPF can operate more efficiently by
treating the network as a point-to-point network. For point-to-point
networks, OSPF does not elect a designated router or generate a network link
state advertisement (LSA). Both endpoints of the link must be configured to
operate in point-to-point mode.
Example
The following example shows the options for the ip ospf network command.
console(config-if-vlan1)#ip ospf network ?
broadcast Set the OSPF network type to Broadcast
point-to-point Set the OSPF network type to Point-to-Point

ip ospf priority

Use the ip ospf priority command in Interface Configuration mode to set the
OSPF priority for the specified router interface. Use the no form of the
command to return the priority to the default value.
Syntax
number-value
ip ospf priority
no ip ospf priority
number-value
•
interface. (Range: 0–255)
Default Configuration
1 is the default integer value.
Command Mode
Interface Configuration (VLAN) mode.
— Specifies the OSPF priority for the specified router
OSPF Commands
1231