udld port
Use the udld port command in Interface (physical) Configuration mode to
select the UDLD operating mode on a specific interface.
Use the no form of the command to reset the operating mode to the default
(normal).
Syntax
udld port aggressive
no udld port
•
aggressive—Sets the port to discover peers in aggressive mode.
Default Configuration
Normal mode is configured by default when UDLD is enabled on an
interface.
Command Mode
Interface (physical) Configuration mode
User Guidelines
In aggressive mode, UDLD will attempt to detect a peer by sending an
ECHO packet every seven seconds until a peer is detected.
show udld
Use the show udld command in User EXEC or Privileged EXEC mode to
display the global settings for UDLD.
Syntax
interface-id
show udld [
|all]
Default Configuration
This command has no default setting.
787
UDLD Commands