Show Interfaces Counters - Dell Networking 2024 Reference Manual

Port Description
--------- ------------------------------ ------ ------- ---- ----- -----
Gi1/0/1

show interfaces counters

Use the show interfaces counters command in User EXEC mode to display
traffic seen by the interface.
Syntax
show interfaces counters [errors] [gigabitethernet unit/slot/port | port-
port-channel-number | tengigabitethernet unit/slot/port |
channel
fortygigabitethernet unit/slot/port]
• errors—Show the error counts (frame discards and reasons) in the in and
out direction.
gigabitethernet—Shows the traffic for the specified Gigabit Ethernet port.
•
port-channel—Shows the traffic for the specified port channel port.
•
• tengigabitethernet—Shows the traffic for the specified 10-Gigabit
Ethernet port.
• fortygigabitethernet—Shows the traffic for the specified 40-Gigabit
Ethernet port.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
The following table describes the fields shown in the display:
Field
InOctets
388
Ethernet Configuration Commands
Description
Counted received octets.
Duplex Speed Neg
Full 1000 Auto 1518
MTU Admin
State
Up