Ipv6 Enable (Oob Configuration); Ipv6 Gateway (Oob Configuration) - Dell Networking 2024 Reference Manual

ipv6 enable (OOB Configuration)

Use the ipv6 enable command in Interface (out-of-band) Configuration
mode to enable IPv6 operation on the out-of-band interface. Prefixes
configured by the ipv6 address command are not configured until the
interface is enabled.
Syntax
ipv6 enable
no ipv6 enable
Default Configuration
By default, IPv6 is not enabled on the out-of-band port.
Command Mode
Interface (out-of-band) Configuration mode
User Guidelines
There are no user guidelines for this command.

ipv6 gateway (OOB Configuration)

Use the ipv6 gateway command in Interface (out-of-band) Configuration
mode to configure the address of the IPv6 gateway. The gateway is used as a
default route for packets addressed to network devices not present on the
local subnet. Use the no form of the command to remove the gateway
configuration.
Syntax
ipv6-address
ipv6 gateway
no ipv6 gateway
ipv6-address —An IPv6 address (not a prefix).
•
Default Configuration
By default, no IPv6 gateway is configured.
491
IP Addressing Commands