Iscsi Target Port - Dell Networking 2024 Reference Manual

AE Selector = 1
AE Protocol = 3260
AE Priority = priority configured for iSCSI PFC (the VPT value above). This
TLV is sent in addition to any Application Priority TLV information received
from the configuration source. If the configuration source is sending iSCSI or
FCoE application priority information, it is not necessary to enable iscsi cos
to send the iSCSI Application Priority TLV.
Example
In the following example, iSCSI is globally enabled.
console(config)#iscsi enable

iscsi target port

Use the iscsi target port command in Global Configuration mode to
configure iSCSI port(s), target addresses and names. To delete iSCSI port(s)
or target ports, use the no form of this command.
Syntax
iscsi target port
targetname
[name
no iscsi target port
tcp-port —TCP port number or list of TCP port numbers on which iSCSI
•
target(s) listen to requests. Up to 16 TCP ports can be defined in the
system in one command or by using multiple commands.
ip-address —IP address of the iSCSI target. When the no form is used, and
•
the tcp port to be deleted is one bound to a specific IP address, the address
field must be present.
targetname —iSCSI name of the iSCSI target. The name can be statically
•
configured; however, it can be obtained from iSNS or from sendTargets
response. The initiator MUST present both its iSCSI Initiator Name and
the iSCSI Target Name to which it wishes to connect in the first login
request of a new session or connection. The target name can consist of any
printable character except for an exclamation point or a double quote as
540
iSCSI Optimization Commands
tcp-port-1 tcp-port-2.... tcp-port-16
[
]
tcp-port-1 tcp-port-2.... tcp-port-16
[
ip-address
[address
ip-address
[address
]
]