Ip Netdirbcast; Ip Policy Route-Map - Dell Networking 2024 Reference Manual

ip netdirbcast

Use the ip netdirbcast command in Interface Configuration mode to enable
the forwarding of network-directed broadcasts. When enabled, network
directed broadcasts are forwarded. When disabled they are dropped. Use the
no form of the command to disable the broadcasts.
Syntax
ip netdirbcast
no ip netdirbcast
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example defines the IP address and subnet mask for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ip netdirbcast

ip policy route-map

Use this command to apply a route map on an interface. Use the no form of
this command to delete a route map from the interface.
Syntax
ip policy route-map
no ip policy route-map
• map-tag —Name of the route map to use for policy based routing. It must
match a map tag specified by the
map-tag
map-tag
route-map command.
IP Routing Commands
1049