Logging Email Message-Type To-Addr - Dell Networking 2024 Reference Manual

severity —If you specify a severity level, log messages at or above the
•
severity level are e-mailed. The severity level may either be specified by
keyword or as an integer from 0 to 7. The accepted keywords, and the
numeric severity level each represents, are as follows.
– emergency (0)
– alert (1)
– critical (2)
– error (3)
– warning (4)
– notice (5)
– info (6)
– debug (7)
Default Configuration
The default severity level is info(6).
Command Mode
Global Configuration mode
User Guidelines
You can filter log messages that appear in the buffered log by severity level.
You can specify the severity level of log messages that are e-mailed. You can
use this command to specify the severity level at which SNMP traps are
logged, and thus control whether traps appear in the buffered log or are e-
mailed and, if they are e-mailed, whether traps are considered urgent or non-
urgent.

logging email message-type to-addr

Use the logging email message-type to-addr command in Global
Configuration mode to configure the To address field of the e-mail. The
message types supported now are urgent, non-urgent, and both. For each
supported severity level, multiple e-mail addresses can be configured. For
example, for urgent type of messages, there could be multiple addresses
configured.
E-mail Alerting Commands
361