Show Ipv6 Dhcp Interface (Privileged Exec) - Dell Networking 2024 Reference Manual

show ipv6 dhcp interface (Privileged EXEC)

Use the show ipv6 dhcp interface command in Privileged EXEC mode to
display configuration and status information about an IPv6 DHCP interface
or all interfaces.
Syntax
show ipv6 dhcp interface [
interface-id —Any valid IP interface. See
•
for interface representation.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC, Configuration mode and all Configuration submodes
User Guidelines
This command shows the DHCP status. Information displayed depends on
the mode.
The command output provides the following information for an interface
configured in client mode. Not all fields will be shown for an inactive client.
Term
Mode
State
Server DUID
T1 Time
970
DHCPv6 Commands
interface-id
Description
Displays whether the specified interface is in Client, Relay, or
Server mode.
State of the DHCPv6 Client on this interface. The valid values
are:
INACTIVE, SOLICIT, REQUEST, ACTIVE, RENEW,
REBIND, RELEASE.
DHCPv6 Unique Identifier of the DHCPv6 Server on this
interface.
The T1 (in seconds) time as indicated by the DHCPv6 Server.
T1 value indicates the time interval after which the address is
requested for renewal.
]{statistics}
Interface Naming Conventions