Ip Pim Join-Prune-Interval - Dell Networking 2024 Reference Manual

User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan10)#ip pim hello-interval 20

ip pim join-prune-interval

The ip pim join-prune-interval command in Interface (VLAN)
Configuration mode to administratively configure the frequency of
join/prune messages on the specified interface. Use the no form of this
command to return the configuration to the default.
Syntax
ip pim join-prune-interval
no ip pim join-prune-interval
interval — The number of seconds between successive join-prune
•
transmissions. Range: 0–18000 seconds. Default is 60.
Default Configuration
The default join/prune interval is 60 seconds.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
This command only has an effect if sparse mode is enabled.
Example
console(if-vlan10)#ip pim join-prune-interval 30
1148
Multicast Commands
interval