Distance Ospf - Dell Networking 2024 Reference Manual

Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets a value of 50 for the default metric.
console(config-router)#default-metric 50

distance ospf

The distance ospf command sets the preference values of OSPF route types
in the router. Lower route preference values are preferred when determining
the best route. The type of OSPF route can be intra, inter, external. All the
external type routes are given the same preference value. Use the no form of
this command to reset the preference values to the default.
Syntax
distance ospf {[
no distance ospf {
intra-area dist1 —Used to select the best path within an area when there
•
are two or more routes to the same destination from two different routing
protocols (Range: 1–255).
inter-area dist2 —Used to select the best path from one area to another
•
area when there are two or more routes to the same destination from two
different routing protocols (Range: 1–255).
external dist3 —Used to select the best path for routes from other routing
•
domains, learned by redistribution when there are two or more routes to
the same destination from two different routing protocols (Range: 1–255).
1220
OSPF Commands
intra-area dist1
] [
intra-area inter-area
|
inter-area dist2
] [
external
|
external dist3
]}
}