Show Ipv6 Route - Dell Networking 2024 Reference Manual

Neighbor Last
IPv6 Address
-------------------- ----------------- -----

show ipv6 route

Use the show ipv6 route command in User EXEC or Privileged EXEC mode
to display the IPv6 routing table. The output of the command also displays
the IPv6 address of the default gateway and the default route associated with
the gateway.
Syntax
show ipv6 route [ipv6-address |
nterface-type interface-number
i
• ipv6-address—Specifies an IPv6 address for which the best-matching
route would be displayed.
• protocol—Specifies the protocol that installed the routes. Is one of the
following keywords: connected, ospf, static.
ipv6-prefix/ prefix-length —Specifies an IPv6 network for which the
•
matching route would be displayed.
interface-type interface-number —Valid IPv6 interface. Specifies that the
•
routes with next-hops on the selected interface be displayed. Supported
interface types are VLAN, Tunnel, and Loopback.
• best—Specifies that only the best routes are displayed. If the connected
keyword is selected for protocol, the best option is not available because
there are no best or non-best connected routes.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC modes, Configuration mode and all
Configuration submodes
1124
IPv6 Routing Commands
MAC Address
ipv6-prefix
] [best]
isRtr State Updated
Interface
------- ---------
prefix-length
/
| protocol |