Dell Networking 2024 Reference Manual page 892

for transmission. If executed in Interface mode, the interface configuration
overrides the global configuration for that interface. Entering the command
with no parameters enables transmission of all TLVs.
Use the no form of the command to return the configuration to the default
settings.
Syntax
lldp tlv-select dcbxp [ets-config|ets-recommend|pfc|application-
priority|congestion-notification] [dcb enable]
no lldp tlv-select dcbxp [ets-config|ets-recommend|pfc|application-
priority|congestion-notification] [dcb enable]
• Ets-config—Transmit the ETS configuration TLV.
• Ets-recommend—Transmit the ETS recommendation TLV.
• Pfc—Transmit the PFC configuration TLV.
• Application-priority—Transmit the application priority TLV.
• Congestion-notification—Transmit the congestion notification TLV.
Default Configuration
The default value is to transmit all DCBX TLVs as received from the auto-
configuration configuration source port. In manual mode, the default is to
transmit all DCBX TLVs per the switch (global or interface) configuration.
Command Mode
Global Config, Interface Config
User Guidelines
NOTE: This command is only available on N40xx series switches.
Global configuration and interface configuration are separate. Interface
configuration overrides the global configuration on a configured interface.
Example
The following example configures the port to not transmit any DCBX TLVs.
console(interface-config-te1/0/1)#no lldp tlv-select dcbxp
892
Data Center Bridging Commands