Dell Networking 2024 Reference Manual page 1633

auth — Specifies authentication of a packet without encrypting it
•
priv — Specifies authentication and encryption of a packet.
•
seconds — Number of seconds to wait for an acknowledgment before
•
resending informs. This is not allowed for hosts configured to send traps.
The default is 15 seconds. (Range: 1-300 seconds.)
retries — Maximum number of times to resend an inform request. This is
•
not allowed for hosts configured to send traps. The default is 3 attempts.
(Range: 0-255 retries.)
port — UDP port of the host to use. The default is 162. (Range: 1-65535.)
•
filtername — A string that is the name of the filter that define the filter for
•
this host. If unspecified, does not filter anything. (Range: 1-30 characters.)
Default Configuration
Default configuration is 3 retries and 15 seconds timeout.
Command Mode
Global Configuration mode
User Guidelines
The username can include any printable characters except a double quote or
question mark. Enclose the string in double quotes to include spaces within
the key. The surrounding quotes are not used as part of the key. The CLI does
not filter illegal characters but may accept entries up to the first illegal
character or reject the entry entirely.
Example
The following example identifies an SNMPv3 host.
console(config)# snmp-server v3-host 192.168.0.20
The following example shows the syntax of the no snmp-server host ip-address
command.
console(config)#no snmp-server host 1.2.3.4 ?
informs Sends SNMP informs to this host.
traps Sends SNMP traps to this host.
SNMP Commands
1633