Banner Exec - Dell Networking 2024 Reference Manual

asset-tag
Use the asset-tag command in Global Configuration mode to specify the
switch asset tag. To remove the existing asset tag, use the no form of the
command.
Syntax
unit
asset-tag [
unit
no asset-tag [
unit — Switch number. (Range: 1–12)
•
tag — The switch asset tag.
•
Default Configuration
No asset tag is defined by default.
Command Mode
Global Configuration mode
User Guidelines
The asset-tag command accepts any printable characters for a tag name
except a double quote or question mark. Enclose the string in double quotes
to include spaces within the name. The surrounding quotes are not used as
part of the name. The CLI does not filter illegal characters and may accept
entries up to the first illegal character or reject the entry entirely.
Example
The following example specifies the switch asset tag as 1qwepot. Because the
unit parameter is not specified, the command defaults to the master switch
number.
console(config)# asset-tag 1qwepot

banner exec

Use the banner exec command to set the message that is displayed after a
successful login. Use the no form of the command to remove the set message.
1670
System Management Commands
tag
]
]