Syntax
time
load-interval
no load-interval
•
time —
The number of seconds after which interface utilization is measured
periodically. The time has to be a multiple of 30. (Range 30-600 seconds)
Default Configuration
The default interval is 300 seconds.
Command Modes
Interface Configuration mode, Interface Range Configuration mode, Port
Channel Configuration mode, Port Channel Range Configuration mode.
User Guidelines
This command has no user guidelines.
Example
console(config-if-Gi1/0/1)#load-interval 150
locate
Use the locate command to locate a switch by LED blinking.
Syntax
locate [switch
unit —If multiple devices are stacked, you can choose which switch
•
switch
to identify.
time —LED blinking duration in seconds. Range 1-3600 seconds.
•
time
Default Configuration
Default value is 20 seconds.
Command Mode
Privileged EXEC
1684
System Management Commands
unit ] [time time ]