Table of Contents
Advertisement
Connecting to
the Network
From the Live50 Board
From a Network Interface board
Restarting Your
PC
The Live50 connection to the network is made from a socket in the
network interface board to a network service jack. To connect your
PC to the network, follow the procedure below for the network
interface board you have installed.
To connect to an ISDN BRI network:
1. Plug one end of the 8-pin modular network cable into the RJ-45
socket labeled ISDN on the Live50 board.
2. Plug the other end of the cable into the network service jack.
If you are connecting to a network using an optional network
interface board, refer to Appendix C for specific information about
your connection.
After you connect all of the Live50 components and connect your
system to the network, power on your PC.
You're now ready to install the PictureTel Live software. Refer to
Chapter 4 for software installation instructions.
Connecting to the Network
2-21
Advertisement
Table of Contents
