PictureTel LIVE50 Installation Manual page 74

INSTALLING PICTURETEL LIVE SOFTWARE
4-6
instead, perform the Windows 95 Driver Selection procedure
described below.
To install the appropriate driver from the Windows 3.1x desktop,
follow these steps.
1. Open the Main program group and select (double-click) Windows
Setup
Windows displays the Windows Setup window.
2. From the Options menu, select Change System Settings...
Windows displays the Change System Settings window.
3. Click on the Display bar or on the down arrow next to the Display
bar.
A scrollable list of display drivers appears.
4. Press the down arrow until you highlight Other display (Requires
disk from OEM)..., and press Enter.
5. Insert the disk labeled VGA Driver into the diskette drive.
6. Enter the appropriate drive at the prompt and press Enter.
7. Highlight the VGA driver you want to use and press Enter.
The VGA driver you select must match the resolution of your
PC monitor. If you don't know the resolution of your monitor,
refer to your PC documentation.
When you select a VGA driver and press Enter, a confirmation
screen appears displaying your selected driver.
8. Press Enter to accept your selected VGA driver.
9. Close the windows and return to the desktop
10. Remove the VGA disk from the diskette drive.
11. Open a Windows application to verify that the VGA board is
working properly.
If your selected setting causes your video display to appear
distorted, you need to run the setup program again and try a lower
resolution. This happens when the video display chip on your VGA
board is incompatible with your selected setting.