Opening Your Pc; Replacing Your Vga Board - PictureTel LIVE50 Installation Manual

INSTALLING PICTURETEL LIVE50 HARDWARE

Opening Your PC

Replacing Your
VGA Board
2-4
To open your PC and prepare it for the Live50 board, follow these
steps:
1. Power off your PC.
Leave your PC connected to the power source to provide a
ground connection.
Do not connect or disconnect hardware components when
your PC is on. Doing so may damage the hardware.
2. Disconnect your monitor cable, and other cables if necessary,
from the PC chassis.
3. Remove the chassis cover.
Refer to your PC documentation for instructions.
The first step of the PictureTel Live50 hardware installation is to
replace your current VGA board with the VGA board shipped with
the Live50:
1. Remove your current VGA board (or follow the instructions in your
PC documentation for disabling the VGA from the motherboard).
2. Insert the VGA board shipped with your Live50 system.
For detailed instructions, see the documentation shipped with
the VGA board.
Note: The VGA drivers for your VGA board need to be
installed after you have finished with the Live50
hardware installation. Refer to Chapter 4, Installing
PictureTel Live Software for installation instructions.
When you're done, keep your PC chassis cover off, because
you'll be installing the Live50 board next.
Caution