PictureTel LIVE50 Installation Manual page 42

INSTALLING PICTURETEL LIVE50 HARDWARE
3
3A
7
2-14
The cables for the speakerphone unit and the FlipCam are
similar, but they are not interchangeable. The end plugs on
the FlipCam cable are labeled
Speakerphone cable are labeled
wrong cable, you might damage the Live50 components.
Be careful when you connect or disconnect the cable. When
connecting the cable, be sure the flat side of the plug lines
up with the flat side of the socket, as shown by the socket
label. When disconnecting the cable, be sure to release the
collar lock by pulling on the plug's collar, not on the cable.
3. Plug the end of the cable without the ferrite bead into the socket at
the back of the camera near the hinge.
Both the plug and the socket are labeled
securely into the socket.
4. Press the cable into the guide on the camera base.
5. Connect the Live50 FlipCam Adapter cable to the FlipCam cable.
Both plugs are labled
6. Be sure your PC is turned off.
7. Plug the yellow connector at end of the FlipCam Adapter cable into
the camera socket labeled
8. Plug the male end of the parallel section of cable on the FlipCam
Adapter into the female socket labeled
Both the plug and the socket are labeled
The other end of this portion of cable is left open for connecting
the Speakerphone cable. The plugs on this cable and the
Speakerphone cable are both labeled
If you are using the earpiece instead of the Speakerphone, this
section of cable must still be connected to the Live50 board to
supply power to the FlipCam.
Caution
, and the plugs on the
8A
. If you connect the
7
8A
.
8A
on the Live50 board.
7
.
7
. Push the plug
on the Live50 board .
.
7