Windows 95 Driver Selection - PictureTel LIVE50 Installation Manual

After you verify that the VGA board is working properly, follow the
instructions in the next section for using the SetupWizard.

Windows 95 Driver Selection

For Live100 systems, or Live50 systems using the PictureTel VGA
board for an ISA bus, running in a Windows 95 operating system,
perform the following Windows 95 Driver Selection procedure:
1. Click on the Start button, point to Settings, and click on Control
Panel.
2. Double click on the Display icon.
3. Click on the Settings tab page.
4. Click on the Change Display type button.
5. Click on the Change button in the Adapter Type area.
6. Make sure the Show all devices setting is selected.
7. Select Tseng Labs from the Manufacturers area and the Tseng
Labs ET4000 /W32 driver from the Models area of the window.
8. Click OK to apply the change.
You are prompted to restart your computer to apply the changes to
the display settings.
9. Open a Windows application to verify that the VGA board is
working properly.
If your selected setting causes your video display to appear
distorted, you need to run the setup program again and try a lower
resolution. This happens when the video display chip on your VGA
board is incompatible with your selected setting.
After you verify that the VGA board is working properly, follow the
instructions in the next section for using the Setup Wizard.
Installing the VGA Driver
4-7