PictureTel LIVE50 Installation Manual page 161

Line Code
Digital Subscriber Line
(DSL)
Service Provider ID
(SPID)
Directory Numbers (DN)
DSL CLS
B1 SERV
B2 SERV
D-Channel
CSV
CSV CHL
CSD
CSD channel
CSV LIMIT
CSD LIMIT
MAXB CHNL (maximum
B-channel)
MTERM
TERMTYP (Term. type)
ACT USR
* Software releases prior to 5E6 (5E5 and 5E4.2) support only AMI line coding.
** NI-1 was first supported in the 5E8 software release
NOTE: Most SPIDs have one of the following formats: 01-7 digit DN, and an optional digit (for example, 01-332-7834-1, or any 3
digits (usually an area code), 7 digit DN, additional optional digits (for example, 700-737-3290-01).
AT&T 5ESS Switch Information
Custom
Version 5E6 or
Higher*
Non-Initializing
2B1Q* 2B1Q*
Point-to-Point Multipoint
Two required
Not needed for this
configuration
Two required. One
One is assigned for
for each B-channel
both B-channels
Point-to-Point Multi-point
DMD for circuit DMD for circuit
switched voice/data switched voice/data
DMD for circuit switch DMD for circuit
data switch data
Signaling only (no Signaling only (no
packet-switched data) packet-switched
data)
1 1
B1 B1
2 2
Any Any
1 1
2 2
Must be set to 2. Must be set to 2.
1 2
Type A Type A
Must be set to YES Must be set to YES
National ISDN
Custom
(NI-1 and NI-2)
Version 5E6 or
Version 5E8 or
Higher*
Fully initializing
2B1Q*
Standard
One assigned by
telephone company
One is assigned for
both B-channels
DMD for circuit
switched voice/data
DMD for circuit
switch data
Signaling only (no
packet-switched
data)
1
B1
2
Any
1
2
Must be set to 2
2
Type A
Must be set to YES
What You Need to Provide
National ISDN
(NI-1 and NI-2)
Version 5E8 or
Higher**
NI-2 - 1 DN NI-1 - 2 DNs
2B1Q*
Standard
Two assigned by
telephone company.
Two (one for each B-
channel)
DMD for circuit
switched voice/data
DMD for circuit switch
data
Signaling only (no
packet-switched data)
1
B1
2
Any
1
2
Must be set to 2
2
Type A
Must be set to YES
Higher**
D-3