PictureTel LIVE50 Installation Manual page 123

Connecting the Switched-56 Network Interface Board
The Network Interface board needs to be connected to either the
Live100 Audio Communications board or the Live50 board using
the supplied MVIP cable. The MVIP cable for the Live100 product
can be identified by the 40-pin connectors on each end. The CHI to
MVIP cable for the Live50 product uses a 40-pin connector for
attaching the Network Interface card and an 8-pin Molex connector
for attaching to the Live50 board.
Connecting the Live100 MVIP Cable
For the Live100 product, connect the Switched-56 Network Interface
board to the Audio Communications board by using the supplied
ribbon cable with a 40-pin connector on each end.
Use care when connecting the MVIP cable to the board so as
not to damage the pins.
Installing the Switched-56 Network Interface Board
Live100 MVIP Cable
(Part #510-0167-01)
Caution
Live50 CHI to MVIP Cable
(Part #180-0293-01)
C-13