PictureTel LIVE50 Installation Manual page 134

INSTALLING NETWORK INTERFACE BOARDS
Inserting the DDM/Network Interface Board into the PC
Connecting the DDM/Network Interface Board
C-24
To install the DDM/Network Interface board into the PC:
Turn off the computer and all peripheral devices before
performing the following procedures.
1. Select an expansion slot that is no more than one slot away from
the Live100 Audio Communications board, or the Live50 board.
2. Remove the filler plate on the expansion slot you have selected for
this board and save the screw.
3. Insert the board into an available ISA expansion slot.
4. Make sure the board is securely seated into the PC.
5. Secure it with the screw that held the filler plate.
The DDM/Network Interface board needs to be connected to either
the Live100 Audio Communications board or the Live50 board
using the supplied MVIP cable. The MVIP cable for the Live100
product can be identified by the 40-pin connectors on each end. The
CHI to MVIP cable for the Live50 product uses a 40-pin connector
for attaching to the Network Interface card and an 8-pin Molex
connector for attaching to the Live50 board.
Caution