Table of Contents
Advertisement
Installing the
VGA Driver
Windows 3.1 x PictureTel VGA Driver Installation
3. Install the Windows 3.1 or the Windows 95 version of LiveShare
Plus. (After this install, Windows will be restarted.)
4. Install the PictureTel Live application. (After this install, Windows
will be restarted.)
The VGA driver you need to install depends on which Live system
you are installing and which Windows operating system you are
running. There are four different VGA driver installation/selection
procedures described below that should address your specific
installation requirements. Choose one of the following procedures
to install your VGA drivers:
If you are running Windows 3.1x, and you have installed the
!
PictureTel Live100 system, or the Live50 system with a
PictureTel VGA board for an ISA bus, refer to the Windows 3.1x
PictureTel VGA Driver Installation procedure described below.
If you are running Windows 95, and you have installed the
!
PictureTel Live100 system, or the Live50 system with a
PictureTel VGA board for an ISA bus, refer to the Windows 95
Driver Selection procedure described below.
If you are running Windows 3.1x, and you have installed the
!
PictureTel Live50 system with a Matrox! or Compaq QVision!
VGA board for a PCI bus, refer to the Windows 3.1x Non-
PictureTel VGA Driver Installation procedure described below.
If you are running Windows 95, and you have installed the
!
PictureTel Live50 system with a Matrox! VGA video board,
refer to the Windows 95 Matrox Driver Installation procedure
described below.
Note: When you install the VGA drivers, set the screen
resolution to 1024 x 768 (no higher) at 60 Hz and select
256 or more colors.
PictureTel provides the VGA drivers necessary for Live100 systems
and Live50 systems using the PictureTel VGA board for an ISA bus,
running in a Windows 3.1x operating system. For Windows 95
systems, do not install the drivers provided on the VGA disk,
Installing the VGA Driver
4-5
Advertisement
Table of Contents
